Make sure it’s set to Direct Access.Įscape all the way out of engineer mode, this will then learn the DualCom on the bus line and will add Com Mod 4. ![]() (56.4.3.1) Enter 1 = Access period make sure it’s set to Full.(56.4.2.4) Enter the last 6 digits of the Connection ID found on M Base.Activate/deactivate any alarm groups you require (As default: 08 = Omit, 10 = setting, 13 electrical status are all turned OFF). ![]() Enter engineer mode (112233 or 1122 Default code).Enter panel programming (12345 or 1234 Default code).Once the reboot has completed go to CSL My Base and change the panel type on the device to Honeywell-Galaxy2-RS485’.(Display will show N – C – R then reboot) The DualCom Pro will go through its power-up/registration process which will take approximately 2-3 minutes.Connect the DualCom Pro directly to the Galaxy’s 485 – 3 wires A,B, RTN(-) for Pro). ![]() Connect power to the DualCom using AUX supply from the panel.Connect the aerial(s) provided to the DualCom Pro. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |